Furman Sound PM-PRO-E Voltmeter Displays, Power Status LEDs, Mains, Voltage Status, Outlets

8 PM-PRO POWER CONDITIONER/MONITOR

will not be tripped falsely by the transient high inrush currents often encoun- tered when turning on large reactive loads like power amps. Its trip point is unaffected by ambient temperature. The breaker/switch controls power to the eight switched rear panel outlets, but does not affect the voltmeter, the amme- ter, or the status LEDs. If it trips, reduce the load on the PM-PRO and push it back to the ON position. (Note: The PM-PRO-E's circuit breaker is not mag- netic.)

Voltmeter Displays

The PM-PRO informs you of voltage problems at a glance. The following chart

summarizes how the PM-PRO's voltmeter responds to input voltages from extremely low to extremely high.

	90	100	110	120	128
			AC VOLTS
Mains *	Voltage Status		PM-PRO Voltmeter Reading			Outlets
Below 80V	Extreme (Shutdown)		Meter off--Extreme Voltage LED flashes			OFF
80-90	Low Marginal		The LED beneath the 90V mark flashes			ON
90-104	Low		Meter Reads in Low Red			ON
106-108	Medium Low		Meter Reads in Low Yellow			ON
110-120	Normal		Meter Reads in Green			ON
122-124	Medium High		Meter Reads in High Yellow			ON
126-128	High		Meter Reads in High Red			ON
130-140	High Marginal		All Meter LEDs Flash			ON
Above 140	Extreme (Shutdown)		Meter off--Extreme Voltage LED Flashes			OFF

* For PM-PRO-E, double all indicated voltages.

Power Status LEDs

PROTECTION EXTREME

OK VOLTAGE

GROUND

OK

FLASHES

WHEN

SHUT

DOWN