Furuno 1715 manual Mounting using the optional mounting bracket, How to fix the EMI core

3. INSTALLATION

8.Tighten the cable gland to fix the antenna cable.

Gasket

Cable Gland

Tighten gland so this length is within 12 mm.

Antenna unit, inside view

9.Referring to the figure below, fasten the shield cable with a screw (M4 x 10) on the chassis to ground the unit.

Connect 9 pin

13.Fasten the EMI core fixing plate with screw (supplied).

Screw (M4 x 15)

Align bend with corner of chassis.

EMI Core

Fixing Plate

EMI Core

How to fix the EMI core

14.Temporarily close the cover. You will need to open the cover later to confirm magnetron voltage.

Mounting using the optional mounting bracket

A mounting bracket for fastening the antenna unit to a mast (70-125 mm diameter) on a sailboat is optionally available.

Type OP03-93, Code 008-445-080

connector

Connect shield here.

Contents of radome mounting assy.

here (J801).

Connecting antenna cable to antenna unit

10.Attach the EMI core to the antenna cable. Set the EMI core fixing band to the EMI core.

Fixing band

This bend should be facing to the cable entrance.

EMI core fixing band

11.Connect the 9-pin connector of the antenna cable to J801. See the illustration on the previous page for location.

12.Refasten the shield plate with 10 screws. Be sure not to pinch the cable from the rotation detector with the shield plate.

Name	Type	Code No.	Qty
Bolt	M4 x 12	000-804-725	4
Bolt	M8 x 20	000-805-707	8
Mounting	03-018-9001-0	100-206-740	1
plate
Support	03-018-9005-0	100-206-780	1
plate (1)
Support	03-018-9006-0	100-206-790	1
plate (2)
Bracket (1)	03-028-9101-0	100-206-810	1
Bracket (2)	03-028-9102-0	100-206-820	1
Fixing plate	03-028-9103-0	100-206-830	2

1.Remove mounting hardware at the bottom of the antenna base. You may discard the mounting hardware.

2.Assemble the mounting bracket as below and fasten it to a mast.

3.Fasten the antenna unit to the mounting bracket with hexagon head bolts (M10 x 25).

24