1.OPERATION

1.11Measuring the Bearing

The bearing to a target can be measured with the cursor and the EBL (Electronic Bearing Line).

Measuring bearing with the cursor

Operate the cursor pad to place the cursor on the center of the target. Read the bearing to the target at the bottom right corner.

Measuring bearing with the EBL

1.Press the [EBL] key to show the EBL. The message “Place EBL by cursor” appears and “EBL” in the EBL/VRM box is displayed in reverse video. The message is automatically erased after 10 seconds, or you may erase it sooner by pressing any key.

2.Operate the cursor pad to bisect the target with the EBL.

3.Check the EBL readout at the bottom left corner on the screen to find the bearing to the target.

To anchor the EBL, press the [EBL] key. (It is automatically anchored if there is no key operation for about 10 seconds.) To erase the EBL, press the [MENU/ESC] key.

1.12 Shifting the Display

Own ship position, or sweep origin, can be displaced manually or automatically to expand the view field without switching to a longer range. The default shift method is manual and the maximum shift is 60% of range.

If shift is activated when nav data is displayed, the nav data is automatically erased.

1.Use the cursor pad to place the cursor where you want to shift own ship position.

2.Press the [MODE] key to show the Display Mode menu.

DISPLAY MODE

SHIFT (MANUAL)*

NORMAL

ZOOM

NAV DISP

OFF

ON

[MENU/ESC] : Exit.

Display mode menu

*: If SHIFT (AUTO) is shown, open the System menu and set SHIFT MODE to MANUAL. For further details, see SHIFT MODE on page 17.

6nm

EBL

EBL

 

 

EBL 45.6°

 

 

RNG 2.229nm

 

 

 

 

BRG 45.6°

bearing

 

VRM - - - -nm

 

 

TTG 00H28M

 

 

 

 

 

Target

Cursor

Range, bearing and time-to-go to cursor location

3.Press ▲ to choose SHIFT (MANUAL).

4.Press the [MENU/ESC] key to close the menu.

Choose

manual

SHIFT

mode.

How to measure bearing by

the EBL and cursor

Select where to shift

Shifted display

with the cursor.

 

How the manual shift works

To cancel the shifted display, open the Display Mode menu, set SHIFT to NORMAL and then press the [MENU/ESC] key.

7

Page 15
Image 15
Furuno 1715 Measuring the Bearing, Shifting the Display, Measuring bearing with the cursor, Measuring bearing with the EBL