Furuno 1932 MARK-2 1.3Fastening the Radiator to the Radiator Bracket, Mounting the Scanner Unit

1.3Fastening the Radiator to the Radiator Bracket

For your reference, scanner installation ma- terials list appears in the packing lists at the back of this manual.

1.Remove the radiator cap from the radia- tor bracket.

2.Coat contacting surface between scan- ner radiator and radiator bracket with an- ticorrosive sealant as shown in Figure 1-2 (scanner unit XN10A) or Figure 1-3 (scan- ner unit XN12A).

Coat hatched area with

anticorrosive sealant.

Groove

Radiator

Figure 1-2 Coating the bottom of scanner radiator for XN10A with anticorrosive sealant

RADIATOR BRACKET

(top view)

10mm

Coat hatched area with anticorrosive sealant.

Figure 1-3 Coating scanner bracket for XN12A with anticorrosive sealant

3.Coat threaded holes on the scanner ra- diator with anticorrosive sealant.

4.Grease the O-ring and set it to the radia- tor bracket.

5.Lay the scanner radiator on the radiator bracket.

6.Coat the radiator fixing bolts (4 pcs.) with

anticorrosive sealant. Fasten the scanner radiator to the radiator bracket with the radiator fixing bolts, flat washers and spring washers.

Scanner radiator

	Coat threaded
	holes with anti-
O-ring	corrosive
	sealant.
Radiator bracket
Flat washer
Spring washer
Hex head bolt
(M8 x 30)	Coat bolts with
	anticorrosive
	sealant.

Figure 1-4 Fastening the radiator bracket to the scanner unit chassis (shown: XN12A)

1.4 Mounting the Scanner Unit

The scanner unit can be mounted using the fixing holes on the outside (240 x 240 nm) or inside (140 x 150 nm) the scanner unit.

Outside fixing holes

Use the hex head bolt ( supplied ) to mount the scanner unit as below.

1. Lay the corrosion-proof rubber mat ( sup- plied) on the mounting platform.

Ground terminal

Rubber mat

Bow mark

Figure 1-5 Location of rubber mat

1-2