Furuno CH270 manual Operator Training

CH270 Installation Check Sheet - continued

CH181 or CH184 Hull Unit Check List

Check and note actual input voltage:
Are all cables and connections tight and strapped?		❏ Yes	❏ No
Is the unit grounded properly?		❏ Yes	❏ No
Has the soundome been lowered and raised by hand?		❏ Yes	❏ No
Have the shaft guides been adjusted for 0.5mm tolerance?		❏ Yes	❏ No
Does the shaft have a heading mark inscribed?		❏ Yes	❏ No
Is the soundome 1/2" up, in the sonar tube when retracted?		❏ Yes	❏ No
Has epoxy been used on shaft threads?		❏ Yes	❏ No
Has soundome packing sponge been removed?		❏ Yes	❏ No
Was oil added to the soundome?		❏ Yes	❏ No
**CAUTION - Do not lay soundome on its side once oil has been added**
Are all the soundome Phillips Head screws tight?		❏ Yes	❏ No
Have 3 layers of greased cotton packing been used?		❏ Yes	❏ No
Is the safety clamp installed and tightened?		❏ Yes	❏ No
Accessories Check List - if applicable
Checked operation of the SC-05WR external speaker?		❏ Yes	❏ No
Checked operation of the CH256 handheld remote control?		❏ Yes	❏ No
Sea Trial Check List
Date:	Location:
Operator:
Sea conditions:
Maximum detection range for the sea-bottom:
Maximum detection range for fish targets:
Has the sonar picture been checked for alignment?		❏ Yes	❏ No
Has the auto-retraction feature been checked?		❏ Yes	❏ No
Have the system manuals been given to the operator?		❏ Yes	❏ No
Was any hoist movement noted at maximum speed?		❏ Yes	❏ No
Operator Training
Date:	Location:
Trainer:
Training provided for:

Necessary Follow-up

Required for:

When:

Warranty Card Completed and Sent to Furuno USA

Date:

Page 2