Siemens PC 670 manual Removing and installing the LS 240 drive, Assembly of the LS240 drive

Release 04/02 Maintaining and Extending the Computing Unit

4.5.4Removing and installing the LS 240 drive

To remove and install the LS240 drive, perform the same steps as for installing the floppy disk drive.

1.Open the housing as described in Chapter 4.1.

2.Remove the drive mounting as described in section 4.5.1.

3.Release the cable clamp assembly of the controller flexible cable on and pull the flexible cable out of the plug connection.

4.Undo the two fixing screws (TORX T8) on the housing.

5.Lift the LS240 drive up and out of the housing.

6.Proceed in the reverse order to install the new drive.

Screws for the LS240 cable clamp assembly

LS240 drive fixing screws

Figure 4-16 Assembly of the LS240 drive

Panel PC 670 Computing Unit, Equipment Manual 4-21