Siemens PC 670 manual Error Message Appears on the Screen/Display, Error messages

Fault Diagnosis Release 04/02

6.7Error Message Appears on the Screen/Display

Error messages

The error messages issued by the system BIOS are listed below. Refer to the relevant program manuals in the case of error messages issued by the operating system or programs.

Press F2 during the boot routine to call in the Setup menu (refer to Chapter 5).

Error message on screen	Significance/Advice
Address conflict	Plug and Play Problem
	Contact your technical service department.
Combination not supported	Plug and Play Problem
	Contact your technical service department.
IO device IRQ conflict	Plug and Play Problem
	Contact your technical service department.
Invalid System Configuration	Plug and Play Problem
Data	Set the RESET CONFIGURATION.DATA option in the Advanced
	Setup menu.
	Contact your technical service department.

Allocation Error for ...

Plug and Play Problem

Please revert the last hardware modification. Contact your technical service department.

System battery is dead	Battery on the CPU module is defect or empty.
Replace and run SETUP	Contact your technical service department.
System CMOS checksum bad	Call in SETUP, define settings and store. If this message appears
Run SETUP	during each boot routine, contact your technical service department.
Incorrect Drive A type	Check the SETUP entries for drive A.
Run SETUP
Incorrect Drive B type	Check the SETUP entries for drive B.
Run SETUP
Diskette drive A error	Fault accessing drive A
	Contact your technical service department.
Diskette drive B error	Fault accessing drive B.
	Contact your technical service department.
Failure Fixed Disk	Fault accessing the hard disk.
	Check the SETUP settings
	Contact your technical service department.
Keyboard error	Check that the keyboard is connected correctly.
Stuck Key	Check whether a key on the keyboard is jammed.
System RAM Failed at offset:	Memory error
	Contact your technical service department.
Shadow RAM Failed at offset:	Memory error
	Contact your technical service department.
Extended RAM Failed at offset:	Memory error
	Contact your technical service department.
Failing Bits:	Memory error
	Contact your technical service department.

6-6 Panel PC 670 Computing Unit, Equipment Manual