Why use the Furuno HUB (HUB101):
The Furuno HUB101 allows the Power Synchronization signal to reach the MFDs and other Power Synchronization compatible devices. Here is a list of all devices that support Power Synchronization:
-All NN3D Displays: MFD8, MFD12, MFDBB
-All NN3D Radar Power Supplies: PSU012 and PSU013
-Sounders: DFF1 and DFF3
-AIS: FA30 and FA50
-HUB101
The Power Synchronization signal is transmitted using a normally unused wire of the Ethernet Cable (PIN 4 and Pin 5) thus a
In addition to allow the Power Synchronization signal to pass, the Furuno HUB101 has switch that can be set to “block” this signal thus allowing connection with non- compatible Power Synchronization devices (PC,
The Power Synchronization feature also allows the NN3D’s unique “Data Synchronization” feature to operate properly providing redundancy and Point/Route/Track Data Synchronization between networked MFDs. Failure to enable Power Synchronization in a multiple MFD system could lead to system data loss or unintentional data updating and overwriting!
How to configure Power Synchronization:
The Furuno HUB101 has a switch for each Ethernet port that can enable/disable the Power Synchronization function. When connected to an MFD, the switch must be configured to allow Power Synchronization. When connected to any other device (PC, previous generation sensors…) the switch MUST be configured to disable the Power Synchronization to protect other devices from the Power Synchronization signal. Please refer to the Installation Guide of the HUB101 for more information.
Note: A
32