5.1.2.Basic Plotter/Radar/Fish Finder Installation
This is a single station Plotter/Radar/Fish Finder installation.
The Furuno GPS (FUSA P/N BBWGPS) is directly connected to 7-Pin Port DATA1 of the MFD. Since two Ethernet sensor are on the network (DRS Radar and Fish Finder), a network switch (FUSA P/N HUB101) is necessary. In this case the Radar Power Cable is directly connected to the back of the MFD8/12 (DRSxD (Domes) can be powered directly by any MFD. For DRSxA (Open) check compatibility). The Ethernet side of the DRS Siamese cable may be extended using a coupler (FUSA P/N= RJ4- 5CN-STR) and an Ethernet cable.
Optional Ethernet Cables that can be used:
-2 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-175)
-5 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-176)
-10 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-177)
-Note that the HUB101 and all MFDs have “AUTO MDX” Ethernet Ports. This means that they will automatically adjust for straight and cross-over Ethernet cables!
-Note that this installation will not allow Radar Overlay or ARPA target acquisition. If these functions are desired, a Heading Compass sensor such as the Furuno PG500/SC30/SC50 is required (see next installation example)
66
