Furuno MFD8/12/BB manual ETR 30/60 BBFF1/3

Up-down: Set the distance from the transducer to the antenna unit in the vertical direction.

Port-starboard: Set the distance from antenna unit to the transducer in port-starboard direction. When the transducer is located on the starboard side, set a positive value.

e)Click the Motion Sensor pull-down menu, and choose SC-30 or SC-50/110 if connected.

f)Set the transducer position at the Transducer Position pull-down menus.

g)If the DFF3 is equipped with a water temperature sensor, click the Temperature Port pull-down menu, and choose the temperature source, MJ (NMEA0183 connector), High-frequency or Low-frequency.

Note: For DFF3, set the tap setting in the network sounder after setting up all the MFDs. For details, see the Operator’s Manual for DFF3.

ETR 30/60 (BBFF1/3)

a)Click the Transducer Setup pull-down menu, and choose Model Number or Manual, according to the transducer connected.

Model Number: Furuno’s transducer

Manual: Transducers other than Furuno

b)If you choose Model Number at step a), click the High Frequency and Low Frequency pull-down menus, and choose the applicable model type. For Manual, set the high and low frequencies with the respective pull-down menus.

c)Use the arrow buttons at Transducer Position to set transducer position.

d)If a radar sensor is connected, click the Next button to continue.

If you don’t have any DRS (Radar), click on Exit to finish the installation. If you have radar, click on “Next” to continue the configuration.

59