3.Press the [+] or [-] key to change interval.

4.Press the [AUTO] and [TRUE] keys to- gether more than two seconds to return to the normal mode. The STATUS LED blinks while the equipment is being calibrated and lights when the calibration is completed (re- turn to normal mode). Do not operate the equipment while the LED is blinking; cali- bration will be incomplete.

Setting the output sentence(s)

Select which type(s) of heading data to output. The default setting is HDG.

1.Disconnect the power connector from the sensor.

2.Reattach the connector to the sensor while pressing the [-] key. The PG-1000 is pow- ered on, and LED(s) light to show which output sentence(s) is being output.

AUTO TRUE CALIB STATUS

4.Press the [AUTO] and [TRUE] keys to- gether more than two seconds to return to the normal mode. The STATUS LED blinks while the equipment is being calibrated and lights when the calibration is completed (re- turn to normal mode). Do not operate the equipment while the LED is blinking; cali- bration will be incomplete.

sentence HDG HDT HDM HCC

:On (current selection) :Off

HDG : Magnetic heading,

Magnetic variation value

HDT : True heading

HDM : Magnetic heading

HCC : Compass heading

Figure 17 LED and output sentence

3.Press key(s) corresponding to sentence(s) to output. For example, press the [TRUE] key to output HDT.

Note 1: Several sentences may be output simultaneously. However, delay may result when the output interval is 100 ms or 200 ms.

Note 2: "HDT" outputs true heading data. However, if variation data is not input from the GPS navigator, magnetic bearing will be output.

7

Page 14
Image 14
Furuno PG-1000 manual Press the + or key to change interval, Setting the output sentences