Furuno manual Selecting Mounting Location, Connect the PG-1000 to the battery as shown in right

1.2Selecting Mounting Location

The PG-1000 must be indoor on the horizon- tal plane.

When selecting a mounting location, keep in mind the following points:

•The ambient temperature must be between -15°C and 55° C.

•Vibration at the mounting location should be minimal.

•Install the sensor as far as possible from power cable, ferrous materials.

•Install the sensor ship's center of gravity.

•Align the bow mark with the ship's bow on the fore-and-aft-line.

1.Tentatively select the mounting location. Do not fix it yet.

Ship's bow

Bow mark

Figure 1 PG-1000

2.Connect the PG-1000 to the battery as shown in right.

	BOW
12-24 VDC
+ -	NMEA	AD10
	Å~

Grounding

Sensor (top view)

Red Black

+-

12-24 VDC

Figure 2 Battery connections to PG-1000

3.Turn the ship's mains switch on. This sensor doesn't have power switch.

AUTO TRUE CALIB STATUS

About two minutes later

: On

:Blinking

:Off

: Status depends on settings.

Figure 3 LEDs at power on

4.Confirm that the STATUS LED blinks. Two minutes later it will light. If STATUS LED doesn't blink and then light, suspect sensor error. Reset power.

AUTO TRUE CALIB STATUS

normal

error

: On

: Status depends on settings

: Off

2 Figure 4