5.Press the [AUTO] and [+] keys together more than two seconds.
AUTO TRUE CALIB STATUS
CALIBRATION
AUTO TRUE
INTEGRATED HEADING SENSOR |
Figure 5 Key and LEDs
After the TRUE, CALIB and STATUS LEDs light and AUTO LED blinks, rotate the equipment 360º slowly, keeping it uplight. If three LEDs are lighting, the mounting location is suitable
AUTO TRUE CALIB STATUS
: On
: Blinking
Figure 6
If one or more LED is off, the mounting location is not suitable. Try to change the location, and do step 5 again.
6.Press the [AUTO] and [TRUE] keys to- gether to return to the normal mode. The STATUS LED blinks while the sensor is be- ing calibrated and lights steady when the calibration is completed. Do not operate the sensor while the LED is blinking; calibra- tion will be incomplete.
1.3Mounting
1.Fix the sensor by using screws and washers (supplied). The size of the fixing hole is ø 4.5 mm.
Ship's bow
Bow mark
fixing hole | 130 | |
65 | ||
|
.5 5
141 152
This line should be at right angles to the fore and aft line.
Material: Brass
o All dimensions in mm.
o For added support, use nuts, bolts and washers.
o Secure sufficient clearance around the sensor for maintenance and checking.
Figure 7 Mounting the PG-1000
Note: Do not overtighten the screws or bolts; the sensor may crack.
3
