Gardena 34 E operating instructions Assembly, Fit the upright

Only use permitted extension cables.

Ask your electrician.

Keep the extension cable away from the area you are cutting.

The mains voltage and the equipment voltage stated on the type plate must be the same. If extension cables are used, these must comply with the minimum cross-sections in the table below:

Voltage	Cable	Cross-
	length	section
220 - 240V/ 50 Hz	Up to 20 m	1.5 mm2
220 - 240V/ 50 Hz	20 - 50 m	2.5 mm2

3. Assembly

A brief voltage dip may occur when you switch on your electric lawnmower (due to conditions of the power supply) that may affect other devices (e.g. a lamp may flicker).

This problem should not occur with supply impedances of Zmax < 0,46 Ohm.

GB

Fitting the wheels:All 4 wheels must always be screwed in at the same cutting height (see 4 Operation “Setting the cutting height”).

4 2 1 3

Fit the upright:

0

1.Insert screw 1 through the bore in the hub cap 2 and push the 6-sided head fully into the hub cap 2.

Use wheel hub with short bolt for the front wheel and wheel hub with long bolt for the rear wheel.

2.Press covering cap 3 into the hub cap 2 until it snaps in place.

3.Insert screw 1 through the wheel 4 and screw the wheel 4 firmly in place by hand at the side and ensure it is securely located. Screw in the small wheels (13 cm diameter) at the front and the large wheels (16 cm diameter) at the rear.

The upper part of the upright is preassembled on the 34 E basicMove lawnmower.

1.	Insert long bolt 5 through the lower part of the upright 6 and
	the upright holder 7 from the cable side.
2.	Screw lower part of upright 6 firmly in position with the wing
	nut 8. During this process, the wing nut 8 must be on the

9

D	B
	C

A

5

6

8

7

opposite side to the cable 9.

3. Push upper part of upright 0 into the grooves in the side of the

lower part of the upright 6 until the bores in the upper part 0

and lower part 6 of the upright match precisely.

Check positioning of the plug switch D. The cable 9 must run along the side of the upright and must not cross over itself.

4.Push short bolt with cable guide A on the cable side from outside through the bore 0 in the upper part of the upright 0.

5.Push short bolt without cable guide B from outside through the bore in the upper part of the upright 0.

6.Place both wing nuts 8 on the bolts A / B and tighten firmly.

7.Press cable 9 into the short bolt with cable guide A and fasten to the lower part of the upright 6 with the cable clip C.

13