Kirby appendix Kirby Morgan 37 Assembly, SuperFlow 450 Regulator, Regulator Body, 112

Kirby Morgan 37 & 57

7.12.6 Assembly of the	1) Inspect the interior of the regulator body and make
SuperFlow 450 Regulator	sure that it is clean and there is no foreign matter.
Required Tools:
11/16 inch Open-end Attachment on Torque	2) Install the o-ring into the regulator body.
Wrench
7/8 inch Open-end Wrench, Torque Wrench and 1	3) Place the exhaust valve insert in the regulator body.
3/8 inch Socket	The insert must be oriented so that it seals against
1 /4 inch Flat Blade Attachment on Torque Screw-	the o-ring and the exhaust valve will mate properly
driver	with the insert.
	4) Use a flat blade screwdriver to push the retainer clip
	into the opening in the regulator body for the exhaust
	valve insert. The clip should lock into place.
	5) Install the exhaust valve into the exhaust valve
	insert. Cut off any excess tail from the exhaust valve
	that protrudes into the regulator body.
	To test to see if the insert is installed properly, try to
	spin the insert. It should not turn. You should not be
	able to dislodge the insert by hand. Friction between
	the insert, the o-ring and the regulator body should
	hold the insert in its proper position.

The regulator body must be clean and free of foreign matter.

S.S. Regulator

Body

Install the o-ring and valve insert. o-ring

Exhaust valve insert

Retainer ring

Exhaust valve

Install the retainer clip. SuperFlow 450 exhaust valve mechanism.

112 © Copyright 1970-2008 Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 080508001