ASSEMBLY THE TABLE EXTENSION (Fig. C)
1.Place the left table extension next to the saw table, aligning the mounting holes (1).
2.Place bolts (2) and thread in mounting holes.
3.Place a straight edge or combination square on the saw table, across the table extension.
4.Adjust the mounting bolts (2) until the extension is flush with the saw table. Tighten.
5.Repeat these procedures for the right extension table.
Fig. C
1
2
ASSEMBLY THE FRONT AND REAR TABLE RAIL (Fig. D, E)
NOTE: Front of table rails assemblies are different.
Assembly the front rail (Fig. D)
1.Attach the right front side cover (1) into right front table rail (2). Repeat for the left front rail.
2.Place the hex. bolts
NOTE: Keep the bolts and square nuts loosened before front rail fixed.
3.Attach the right front rail onto proper location by having the square nuts pass through the slot of the front rail. Repeat for the left front rail.
4.Attach the middle plug (6) to connect the two half front rail. (Fig. E)
5.When the blade was installed, use the rip fence and gauge to adjust the front rail to proper location. When the front rail is level with table, then fix the front rail by tightening the six bolts.
Fig. D
5 4
3
4
6
2 1
Assembly the rear table rail (Fig. E)
6.Attach the side covers (1) and middle plug (2) to the rear table rails (3).
7.Place the rear table rails on the saw table, aligning with the holes in each rail.
8.Place the bolts (4) and tread in the holes; tighten the bolts and check the alignment again.
Fig. E | 4 |
3 1
2
BLADE RAISING HANDWHEEL (Fig. F)
Thread the blade handwheel handle (1) into blade raising handwheel (2) and tighten.
BLADE TILTING HANDWHEEL (Fig. F)
1.Attach the blade tilting handwheel (3) to the elevation screw at the front of the saw.
2.Attach and tighten the dome nut (4) at the end of the shaft.
Fig. F
2
1
3 4
BLADE GUARD ASSEMBLY (Fig. G, H)
WARNING
To avoid injury from an accidental start, make sure the switch is in the OFF position and the plug is disconnected from the power source outlet.
When installing the blade guard, cover the blade teeth with a piece of folded cardboard to protect yourself from possible injury.
Never operate this machine without the safety guard in place for all through sawing operations.
— 13 —
