Contents of Shipping Cartons
Note: unit shipped in two cartons.
Stand Carton
1. Stand with Motor
1. Stand Door
1. Dust Chute w/ Mounting Hardware
Main Unit Carton
1.Bed Assembly w/ Fence
1.Cutter Guard
3.Mounting Bolts
3.3/8" Lock Washers
1.Belt Guard
3.Hex Wrenches (3, 4 & 5mm)
2.Handwheels
2.Handles
2.
1.Can of
1.8/10mm Open End Wrench
1.12/14mm Open End Wrench
1.Owner’s Manual
1.Knife Gauge Assembly
1.Warranty Card
Tools Required for Assembly
#1 Cross Point Screw Driver
Unpacking and Cleanup
1.Carefully remove all contents from both shipping cartons. Compare contents of the shipping car- tons with the list of contents above. Place parts on a protected surface.
2.Report any shipping damage to your local dis- tributor.
3.Clean all rust protected surfaces (bed, fence, etc.) with kerosene or diesel oil. Do not use gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.
CAUTION
Cutterhead blades are extremely sharp!
Use care when cleaning!
4.Apply a thin layer of paste wax to the bright sur- faces of the fence and tables to prevent rust.
5.Set packing material and shipping cartons to the side. Do not discard until machine has been set up and is running properly.
7
