Assembling Knife-Setting Gauge, Fence Adjustment

Assembling Knife-Setting Gauge

1.Place the two bases (A, Fig. 4) onto each end of the bar (B, Fig. 4). Snap the four E-rings (C, Fig. 4) into the grooves on the bar as shown.

Fig. 4

Note: whenever making an adjustment to the fence, lift the fence up slightly after releasing the lock handle to avoid scratching the table.

1.Set infeed table to the same height as the outfeed table.

2.Move the fence by releasing lock handle (A, Fig. 5) and pushing the fence assembly until it overlaps the tables.

3.	Adjust the fence to a 90° angle by releasing	Fig. 5
	lock handle (B, Fig. 5), pulling up on handle (C,
	Fig. 5), and re-tightening lock handle (B, Fig.
	5).
4.	Place a combination square on the infeed table.
	(Fig. 6)
5.	If fence is not square to table, release lock
	handle (B, Fig. 5), loosen nut (D, Fig. 5), and
	turn bolt (E, Fig. 5) until fence is square to table.
6.	Tighten nut (D, Fig. 5) to retain the setting.
	Tighten lock handle (B, Fig. 5).

Fig. 6