Assembly and Adjustments

ESTIMATED ASSEMBLY TIME 50~70 MINUTES (2 PEOPLE) ASSEMBLE STAND (Fig. A)

1.Unpack all parts and group by type and size (Fig. A). Refer to parts list for quantities.

2.Attach one support (4) to leg (1) using one square neck bolt (2) and nut (3).

NOTE: Do not tighten bolts until stand is properly aligned (see step # 7).

3.Attach other end of support to another leg using one square neck bolt and nut.

4.Join front frame assemblies using support (5) square neck bolts and nuts.

5.Join rear frame assemblies using short upper support

(6) and short bottom support (7), square neck bolts and nuts.

6.Place three rubber feet (8) onto three leg and the adjustable foot (9) and nut (10) onto the bracket of the other leg.

7.Attach the hooks (11) and power cord storage (12) to the frame as desired. The hooks are used to hold the fence.

8.Place stand on level surface and adjust so all legs are contacting the floor and are at similar angles to the floor.Tighten all bolts.

NOTE: Stand should not rock after all bolts are tightened.

9.Mounting a caster (13) on each leg by tightening three bolts (14) and nuts (15). Four casters.

NOTE: Two casters marked "A" are used for the Front-

Right & Rear-Left legs, two casters marked "B " are used for the Front-Left & Rear-Right legs.

Fig. A

1.Place protective corrugated cardboard or old blanket on floor to protect the saw table surface.

2.Place the saw up-side down on the protective material (Fig. B).

3.Position the recessed-side dust chute and the stand up-side down on the saw base.

NOTE: Make sure front of stand and front of saw are facing the same direction.

4.Line up four holes in saw base, dust chute and stand.

5.Fasten saw to dust chute and stand using four bolts, washers and nuts.

NOTE: Place washer on each bolt before inserting into saw base and through the support. Nut must be flush against the bracket.

6.Tighten all four nuts.

NOTE: Do not overtighten the locknuts mounting the base to the stand (you may damage the base).

7.Carefully set the saw in its upright position on a clean level surface.

8.Push down on the lever of right wheel assemblies to unlock. Push up on the lever of right wheel assemblies to lock.

NOTE: You will need assistance form another person.

1 11

14	— 12 —