Hitachi C10FL instruction manual Product Specifications, Motor SAW, Yes

WARNING

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

•Lead from lead-based paints

•Crystalline silica from bricks, cement and other masonry products

•Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks that are specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

MOTOR		SAW
HP (Maximum developed)	3.0	Table Size	27-1/8” x 20-1/8”
Type	Induction	Table Extensions	Left & Right
Amps	15 / 7.5	Extension Fence Capacity	24” Left & Right
Voltage	120 / 240	Blade Size	10”
Hz	60	Rip Scale	YES
RPM (no load)	3450	Rip Fence	YES
Overload Protection	YES	Miter Gauge	YES
		Maximum Cut Depth @ 90°	3-3/8”
		Maximum Cut Depth @ 45°	2-1/4”
		Maximum Dado Cut Width	13/16”
		Net Weight	264.5 LBS

WARNING

To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.

This table saw is wired at the factory for 110-120/220-240 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere or 220-240 Volt / 7.5 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in any way.

Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these rules could result in serious injury to you or damage to the table saw.

— 3 —