Accessories and Attachments, Tools Needed | Hitachi C10FL specification

ACCESSORIES AND ATTACHMENTS

RECOMMENDED ACCESSORIES

WARNING

WARNING

Visit your Hardware Department or see the Power and Hand Tools Catalog to purchase recommended accessories for this power tool.

To avoid the risk of personal injury:

Do not use a dado with a diameter larger than 8".

Maximum dado width is 13/16". DO N OT U S E W IDE R COMBINATIONS.

Do not use molding head set with this saw.

Do not modify this power tool or use accessories not recommended by Store.

TOOLS NEEDED FOR ASSEMBLY

TOOLS NEEDED

Medium screwdriver

Adjustable wrench

#2 Philips screwdriver

Straight edge	Combination square
4mm Hex wrench	5mm Hex wrench
17mm Hex wrench

— 7 —

Image 7

Hitachi C10FL instruction manual Accessories and Attachments, Tools Needed for Assembly, Recommended Accessories

Contents

10FL Hitachi Authorized Service Centers Motor SAW Product SpecificationsYES Check for Damaged or Loose Parts Power Tool Safety Table SAW Safety Guidelines for Extension Cords Electrical Requirements and SafetyPower Supply Requirements Extension Cord Requirements Tools Needed Accessories and AttachmentsTools Needed for Assembly Recommended Accessories Carton Contents Unpacking Your Stationary Table SAW Know Your Stationary Table SAW Workpiece workpiece are edges Glossary of TermsHitachi Professional Table SAW Terms Woodworking Terms Assemble Table SAW to Stand Fig. A, B Assembly and Adjustments Blade Tilting Handwheel Fig. F Assembly the Table Extension Fig. CAssembly the rear table rail Fig. E Blade Raising Handwheel Fig. F To avoid injury from an accidental start, make sure Switch is in the OFF position and the plug is disconnectedFrom the power source outlet Removing the blade guard assembly Fig. H Stop Fig. J Fig. K Blade Tilting Indicator Fig. L Storage Fig. O, P Rip fence and miter gauge Fig. O Installing the Table Insert Fig. NPower Cord Fig. P Mitre Gauge Adjustment Fig. Q RIP Fence Indicator Fig. T RIP Fence Adjustment Fig. RRIP Fence Operation Overload Protection OperationBasic SAW Operations Tilting the Blade Bevel Ripping Ripping Fig. WRipping Small Pieces Mitering Fig. CC Crosscutting Fig. Y To prevent serious injuryBevel Crosscutting Fig. AA Compound Miter Crosscutting Fig. BB Dado Cuts Fig. GG Auxiliary Fence Fig. EE Making the baseMaking the side Putting it together Maintaining Your Table SAW MaintenanceLubrication Terminal Block Symptom Possible Causes Corrective Action Troubleshooting Guide Push Stick Page Parts List for Schematic a Parts ListStationary Table SAW Statonary Table SAW Model NO. C10FL Schematic a Statonary Table SAW Model NO. C10FL Parts List for Schematic B Statonary Table SAW Model NO. C10FL Schematic B Hitachi Koki Canada Co