GB
The temperature of the liquid used must not be below 4 °C or above 35 °C.
Sand and other abrasive substances in the liquid cause increased wear and reduce the output of the pump.
Please observe the local noise prevention regulations.
3. Initial Operation
Starting up the pump:
1 |
2 |
RP 240 |
|
RP 300 |
|
RP 420 | RP 600 |
3 |
1.RP 600: Insert the fountain socket 1 and nozzle tube 2.
2.Install the pump at ground level so that the filter housing is standing in water to at least half its height (with pumps RP 240 / RP 300 / RP 420 make sure that the sides of the foam filter under the pump are not blocked).
3.Plug mains plug into an AC power socket.
Warning: Pump will start immediately.
4.Use the flow control 3 to set the desired water flow for the fountain pump.
18