HINT FOR
Before removing the bulb access panel, pull out the
F. CHANGING POWER SUPPLY CORD (See exploded view on page 15)
(1) Unfasten 1 screw for ground and pull out the
2 wires of the power cord from the terminal plate.
(2)Remove 1 screw for the bottom bracket of the cord bushing.
(3)Install the new power supply cord with the reverse procedure of above (1) to (2).
WARNING:
For changing the power supply cord, never use other than the following.
Key No. Order No. | Parts Name | |
5 | 617 140 1318 | Power cord Ass’y |
6 | 617 140 1332 | Cord bush |
7 | 617 140 1349 | Bottom bracket |
G. REMOVING CERAMIC TRAY ASS’Y
(See Fig.12 )
(1)Take off the cabinet.
(2)Put (insert) a screwdriver in the 9 mm diameter hole located at the lower hinge of left side of the oven cavity. Push the tray up with the screw- driver.
(3)Open the door and take out the tray very care- fully.
NOTES
-After replacing the door, be sure to check that the interlock switch, the door sensing switch
and the interlock monitor swich operate normally. (See pages 1 and 6)
-After replacing the door, check for microwave ene- rgy leakage with a leakage detector. Microwave energy leakage must be below the limit of 5mW/c ‡u.(For US)
-After instaling the door, check for microwave energy with a leakage detector and confirm that the leakage is the below the limit of 1 mW/cm2 (at 275cc waterload),5 mW/cm2 (at no load) and 5 mW/cm2 (at 275cc water load without cabinet) . (For CANADA)
I.HOW TO RESET THE MEMORY OF ACCUMU- LATIVE COOKING TIME
1. Push the keys step by step as follows,
“ CLEAR | “, “ TIME | “, “ 8 “, “ 8 “, “ 8 “, “ 1 “ |
“ START | “, “ START | “. |
The display will show accumulative cooking time in display window.
2. Then push the keys as follows. “ 0 “, “ MEMORY “.
The Memory of Accumulative cooking time will be cleared.
J.RELEASING TYPE CONNECTOR
This oven is provided with locked type connectors. When you remove a connector, pull the connector while releasing the lock by pressing “A” point shown below. Do not pull the wire of the connector.
Connector:
S1, S2, S102, S104, S105 (Figure 13)
Hole
H.REMOVING DOOR
Door
Screw driver
Figure 12
A | A |
|
Figure 13 | Figure 14 |
Pull connector case (Never pull the wire)
Remove 2 hex nuts securing the upper hinge, remove 3 hex nuts securing the lower hinge and remove 1 special screw securing the door arm (located at the bottom of the door sash).
Figure 15
- 14 -