Part # 4500195 (02/20/08) Page 7
INSTALLATION

Siting

The oor on which the appliance is to be sited must be
capable of adequately supporting the weight of the
appliance and any ancillary equipment.
Units with ovens must be tted with legs if installed on a
combustible oor.

Appliances Equipped With Legs

1 Raise the front of the appliance an block. Do not lay the
appliance on its back.
2. Position leg insert in leg retainer opening and tap upward
until the insert seats at the collar ange.
3 Repeat leg insert installation for the other legs and adjust
all four legs to the same height.
4. Legs can be further adjusted to level the appliance and to
compensate for uneven ooring.

Appliances Equipped With Casters

1. The installation shall be made with a connector that
complies with the Standard for Connectors for Movable
Gas Appliances, ANSI Z21.69 /CSA 6.16, and a quick-
disconnect device that complies with the Standard for
Quick-Disconnect Devices for Use With Gas Fuel, ANSI
Z21.41 / CSA 6.9.
2. The front casters on the appliance are equipped with
brakes to limit the movement of the appliance without
placing any strain on the connector or quick-disconnect
device or its associated piping.
3. Please be aware; required restraint is attached to a
bracket (which is located on the rear caster closest to the
gas connection), and if disconnection of the restraint
is necessary; be sure to reconnect the device after the
appliance has been returned to its original position.

Installing Shelf to Backguard

Note: Shelf may be installed before or after installing the
backguard to the range.
1. Loosen 4 bolts on the front of the backguard
approximately 1/4” (6mm).
2. Align the 4 holes on the back of the shelf with the 4 bolts
on the backguard.
3. Slide the shelf downward until the 4 bolts are engaged in
the slotted portion of the keyhole.
4. Tighten the 4 bolts to secure shelf.
5 On 60” and 72” units only, install a sheet metal screw
though the hole in the underside of the shelf into the
backguard and tighten.
SHELF
BACKGUARD
MOUNTING
BOLTS
SHEETMETAL
SCREW

Installing The Backguard Or Shelf

Drawing 1

Upright

Burner Box

Side

#14 x 5/8"

Type "B"

Hex Head

Tapping Screw

4 Req'd

1. Rear of range must be easily accessible.
2. Place the backguard, high shelf, salamander, or
cheesemelter on the rear of the range, slipping the
support brackets into the openings in the burner box
sides.