Installation

Mounting the Transducer

Cable Ties

Worm Gear

Clamp Band

Slide clamp band through slots on transducer

4

Trolling Motor Installation

Included in the 010-10251-00 transducer kit you should have:

1.Worm Gear Clamp

2.Cable Ties

3.Transducer

Mounting the Transducer:

1.Loosen the Worm Gear Clamp until end of the band is clear of the worm gear.

2.Slide the clamp band through the slots on the transducer.

3.Place the free end of the clamp band into the worm gear and tighten until the band is through the worm gear.

4.Place the clamp and transducer over the body of the trolling motor. Finish tightening the clamp to secure the transducer to the trolling motor.

5.Secure the transducer cable to the trolling motor shaft using the supplied cable ties.

If you are experiencing interference while the trolling motor is operating, try installing the transducer cable at right angles to the trolling motor power cables.