Installation

Installing the Display

Be careful not to install screws that are too long!

The mounting holes in the unit are approximately 1/4” deep. Installing screws that are too long will damage the unit and void the warranty.

8

Display Installation (Flush Mount)

The Fishfinder 160 Blue can be mounted flush against a dash or electronics rack that is no more than 1/4” thick.

Flush Mounting the Display:

1.Remove the Mounting Bracket from the back of the unit by removing its four screws.

2Using the Mounting Bracket as a template, mark the location of the four mounting holes and the center relief hole.

3.Drill the mounting holes using a 6mm or 15/64” drill.

4.Using a 1-7/8” hole saw, cut the center relief.

5.Secure the unit to the mounting surface using four M5 screws.

If you are flush mounting the unit on a sheet metal surface, use the mounting bracket on the back to help reinforce the metal. You may also purchase the optional Flush Mounting Kit and follow the flush mounting instructions included with the kit.

Mounting Bracket