Mufﬂer, Right hand guard | Garmin EVA-2082S/1220, 353 specification

MAINTENANCE

necessary with an aluminium chain catcher (is available as spare part).

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

Never use a machine that has a faulty mufﬂer.

Regularly check that the mufﬂer is securely attached to the machine.

Some mufﬂers are equipped with a special spark arrestor mesh. If your machine has this type of mufﬂer, you should clean the mesh at least once a week. This is best done with a wire brush. A blocked mesh will cause the engine to overheat and may lead to serious damage.

Note! The mesh must be replaced if it is damaged. If the mesh is blocked the machine will overheat and this will cause damage to the cylinder and piston. Never use a machine with a mufﬂer that is in poor condition. Never

32 – English

Image 32

Garmin EVA-2082S/1220, 353 manual Mufﬂer, Right hand guard

Contents

Operator′s manual Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear Customer What is WHAT? What is what on the chain saw? General Safety Precautions Before using a new chain saw Machine′s safety equipment Always use common sensePersonal protective equipment Chain brake and front hand guard General Safety Precautions Right hand guard Throttle lockoutChain catcher Stop switch Cutting equipmentVibration damping system Mufﬂer Cutting equipment designed to reduce kickback BarChain Injuries Some terms that describe the bar and chain Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teeth Tensioning the chain Lubricating cutting equipment Which could lead to serious, even fatal injuries Chain oilFilling with chain oil Checking chain lubrication Needle bearing lubrication Checking wear on cutting equipment Assembly Fitting the bar and chainFitting a spike bumper Working with the chain Fuel Handling Fuel Fuel safety FuellingTransport and storage Long-term storage Starting and Stopping Starting and stoppingCold engine Warm engine Stopping Basic safety rules Working TechniquesBefore use General working instructions Jam. Always stop the engine before cleaning Limbing Basic cutting techniqueTerms Tree felling technique Safe distance Felling direction Clearing the trunk and preparing your retreat Directional cuts Felling cut General advice Freeing a tree that has fallen badlyFreeing a trapped tree Cutting trees and branches that are in tension Cutting the trunk into logs How to avoid kickbackWhat is kickback? General MaintenanceCarburettor adjustment Correctly adjusted carburettor High speed jet H Immediately Checking the right-hand brake triggerChecking the brake trigger Mufﬂer Replacement of broken recoil and drive disc springs StarterChanging a broken or worn starter cord Tensioning the recoil spring Air ﬁlter Spark plugLubricating the bar tip sprocket Needle bearing lubrication Adjustment of the oil pump Air Injection centrifugal cleaningRunning when making adjustments Cooling system Winter use Temperature 0C or colderElectrical carburettor heating Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Technical Data Technical data Bar and chain combinations Saw chain ﬁling and ﬁle gauges EN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only Page Page Page Original instructions 1153178-26