4.2.8 CONFIGURATION
Select the Configuration Test Page. Change the selectable Strap and Fuel selections to match that of the aircraft. The available options are:
Strap: Field | Description | |
Lnav 1 | Number 1 | (Pilot) long range NAV |
Lnav 2 | Number 2 | |
common | Common long range NAV |
NOTE: The strap option affects the interpretation of
For
Lnav 1 | Only data marked for Lnav 1 is used |
Lnav 2 | Only data marked for Lnav 2 is used |
common | Data marked for either Lnav 1 or Lnav 2 is used |
For ARINC 429 input data the following applies:
| Lnav 1 | Only data with SDI=0 or SDI=1 is used |
| Lnav 2 | Only data with SDI=0 or SDI=2 is used |
| common | Only data with SDI=0 is used |
| NOTE: SDI=0 is an “all call”. | |
Fuel: | av gas | Using Aviation gas (5.8 lbs/gal) |
| Jet A | Using Jet A/Jet |
| Jet B | Using Jet B |
NOTE: The Fuel option is used to designate the type of fuel used so that the correct fuel density will be used in calculations.
4.2.9REMOTE BATTERY SETTINGS
Remote Battery: none instld
NOTE: If “instld” is selected when a battery is not installed erroneous voltages will be shown on the Power Test page and invalid battery messages will be issued in normal operating modes.
Low Battery: | selectable between 8.0 volts and 9.6 volts by 0.2 volt steps |
NOTE: In normal operating modes, The “Battery Low” message will be issued when the battery voltage is below the low battery value. The default value is 9.0 volts.
Av. Kit Install. Manual
Page 20