Compass Calibration
Example of button sequence below;
Autopilot in Standby
1)Put the autopilot in Setup mode by momentarily pressing 
the setup LED should be lit on the Hand Held
2)Now press 
button the 4 LED will now be on. Now press 
button the 7 LED will now be on and display code “47”
3)Press and hold the 
button, now press and release the Deckmount (on/off)
button quickly,
the Up Arrow LED | will now | come on now release button |
4)Steer your boat (with the tiller or main engine) on a steady heading, in forward at a low RPM.
5)When Up Arrow LED starts blinking 
steer your boat in a medium to slow starboard turn (with tiller or main engine) and start your first 360 degree circle.
6)When approximately 3 circles are complete 
Down Arrow LED’s will light solid for about 5 seconds completely, the compass calibration is complete
and 
LED’s will extinguish and the Up and the system will then shut down
If Up and Down Arrows both continue to blink and does not power down after 5 seconds, the compass Calibration failed. Shut down system completely and re calibrate compass.
