![](/images/backgrounds/130973/130973-3819x1.png)
Installation
5. Turn the unit off to exit the Test Mode.
Mic Level Adjustment
Those units with audio board p/n
2. Turn the LARGE knob to the MIC 1 LEVEL and MIC 2 LEVEL pages.
3. Press the œ key to start selection (the number will flash).
4. Turn the SMALL knob to change the value. Press MEM to store the value.
5. Turn the unit off to exit the Test Mode.
Display Test
It is possible to perform a simple test to observe all segments of the display for a quick checkout of the display functions.
1. Press and hold the œ and RCL keys while switching the unit on.
2. Turn the LARGE knob to the DISPLAY TEST page.
3. Press MEM to perform the test. A series of “#” symbols will advance across the display testing each LED.
4. Turn the unit off to exit the Test Mode.
Mic Squelch
Adjustments to the squelch levels for Mic1 and Mic2 are available in the System Functions mode. To adjust the Microphone Squelch level:
1.Press and hold the MON button for about two seconds. This will access the System Functions mode.
2.Rotate the LARGE knob to display the MIC1 OR MIC2 SQLCH pages.
3.Rotate the SMALL knob to change the level number. The range of the number is 000 to 127.
4.Press any key to exit the Setup Functions mode.
5.Select an appropriate frequency, key the transmitter, and talk into the microphone to check the level.
Transmit Mic
The Transmit Microphone page allows you to control which microphone is permitted to transmit. You may choose Mic 1, 2, or both. To adjust the Transmit Mic control:
1.Press and hold the MON button for about two seconds. This will access the System Functions mode.
2.Rotate the LARGE knob to display the TRANSMIT MIC page.
3.Rotate the SMALL knob to select MIC1, MIC2, or MIC1+MIC2.
4.Press any key to exit the Setup Functions mode.
5.Select an appropriate frequency, key the transmitter, and talk into the microphones to check for the intended operation.
Apollo SL40 Installation Manual | 13 |