GarrettCom manual Installing 6KPM Cards in the Magnum 6K16V, www . GarrettCom . com

Magnum 6K16V Managed Fiber Switch Installation and User Guide (06/04)

Step 3. Remove front panel face plate retaining screws

There are two PM slots (A, B) located on the front of the chassis cover. Looking into the vertical placed Chassis cover of the unit, there are three brackets with retaining screws (#256 flat head ) which hold each PM Face plate card slot securely. These six screws shown in the picture below are used to secure a PM face plate in position, but unscrew only four of the screws as shown in Fig. below. These screws are also used to secure the individual 6KPM cards screen plate which can be subjected to significant forces from the attached cables. (See Figure 3.6.1c)

Figure 3.6.1c: Top View – 6KPM retaining screws hold Face Plate

3.6.2Installing 6KPM Cards in the Magnum 6K16V

Up to two front-mounted 6KPM cards may be installed in one Magnum 6K16V Managed Fiber Switch unit. Follow these steps to install a 6KPM.

Step 1. Remove top chassis cover. See procedure in Section 3.6.1 above.

Step 2. Placed Granddaughter board (as shown in fig. 3.6.2a and 3.6.2b) on the chassis built in stand off (female) provided at the front of the 6K16V Main Board and screw down tightly with the three 5/16 stand-off (male) on the top of the Granddaughter board The 5/16 stand off has been used to place the daughter board on the top of the granddaughter board and latch it securely.

Fig 3.6.2a Granddaughter Board shown separately

www . GarrettCom . com

27