GarrettCom TB14H manual Connecting ThinNet 10BASE2

TB14 and TB14H 10Mb Media Converters Installation and User Guide (09/04)

1.Using standard 10BASE-T media, insert either end of the cable with an RJ-45 plug into the RJ-45 connector of the Magnum Media Converter.

2.Connect the other end of the cable to the corresponding device.

Use the LINK LED to ensure proper connectivity by noting that the LED will be illuminated when the units are powered and proper connections established. If the LINK LED is not illuminated, change the setting of the up-link switch (See Section 4.6 for up- link switch information.) If this does not help, ensure that the cable is connected properly at both ends and is not defective.

3.6.2Connecting ThinNet (10BASE2)

Note: connect TP media before connecting BNC media if power is on in the

Media Converter unit. See Section 3.6 Connecting Media above.

www . GarrettCom . com

33