Maintaining the projector

Cleaning the projector

Keeping the projector clean and the vents free from dust helps keep it performing at its best.

Warning Make sure that the projector is off, power is disconnected, and the lamp is completely cool (minimum of 30 minutes) before cleaning the projector.

Cleaning the exterior

Always turn off the projector and wait for it to cool before cleaning it.

Use a damp, lint-free cloth to clean the projector case. Do not use abrasive or solvent cleaners because they can damage the finish.

The projector is cooled by air circulated through the vents on the case, so keep the vents free of dust. With the projector turned off and unplugged, brush the dust away from the vents with a damp cloth. Be careful not to drip any water into the vents. Do not attempt to clean dust from the inside the projector.

Cleaning the projector lens

Always turn off the projector and wait for it to cool before cleaning it.

Use a soft cloth and glass cleaner to clean the projector lens. Squirt a little cleaner on the cloth (never directly on the lens), and wipe the lens with the cloth.

Keep the lens cap on when the projector is not being used to protect the lens.

www.gateway.com

39