GBC | Operation Manual |
FRONT CONTROL GUIDE
FIGURE 1.
1.LCD:
•The LCD will display the settings the machine is currently set for.
•Illuminates when the laminator is plugged in and POWER ON/OFF is in the on, (I), position. Displays settings for the top heater, bottom heater, speed, job mode, and ready/wait.
7.Front Roller Press:
•When pressed, the Main Rollers will move to the Press or Down position.
8.Front Roller Release:
•When pressed, Top Main Roller will move to the Up or Release position.
9.Reset:
•When pressed, the counter will reset to “0”.
10.Rear Roller Press:
•When pressed, The Pull Roller or Rear Roller will move to the Press or Down position.
11.Rear Roller Release:
•When pressed, The Pull Roller or Rear Roller will move to the Release or Up position.
12.Cooling:
•When pressed, The Cooling Fans will Turn On. When pressed again, they will turn Off.
13.Start:
•When pressed, The Pull rollers or Rear Roller will move to the Press or Down Position.
14.Stop:
•When pressed, The Rollers will stop rotating.
15.Direction:
•When pressed, the direction of the machine can be changed. Forward and Reverse.
•TOP:
•BOT: - refers to the Bottom Main Rollers temperatures setting.
•Mode:
•Speed: Will display the set speed.
•POS: Will indicate the roll gap or position.
2.Top Set Temp:
•This will display the “Set Temp.” of the Top Main Roller.
3.Bottom Set Temp:
•This will display the “Set Temp.” of the Bottom Main Roller.
4.Speed:
•This will display the “Set Speed.” of the Laminator.
5.Job Mode:
•When pressed, the Job Selection will activate. By rotating the Master Dial, You can select the Job Needed. When Job Save is pressed and held, the current job settings will save for that Job.
6.Master Dial:
•Increases (+) or decreases
© 2009 GBC an ACCO Brands Co. | Page 7 |
