Problem | Solution |
Cannot hear the | • Set the RING/PWR switch on the handset to ON (the far left |
Page alert tone | position). |
|
|
Range is shorter | • Press the CHAN button during the conversation to select a |
than normal | new channel. |
| • Position the base antenna upward. |
|
|
Battery will not hold a | • Be sure you are sufficiently charging the battery. When the |
charge or is fully charged | battery has been charged for 12 hours, you can expect |
and the BAT LOW lights | approximately 4 hours of talk time. |
| • Check to be sure battery contacts on both the handset and |
| the base are making contact and are clean; free of dirt or lint. |
| • When the handset is placed in the base, check that the base |
| CHARGE light is on. |
|
|
BAT LOW light stays on | • Place handset in base for 10 seconds to reset the phone. If |
| that doesn’t work, charge battery for 12 hours. |
|
|
Memory Dialing | • Did you program the memory location keys correctly? |
doesn’t work | • Did you follow proper dialing sequence? |
| • Make sure T/P switch is correctly set. |
|
|
Unit locks up | • If the unit doesn’t work, turn the power switch on the handset |
| off. Hold down digit 2 and 8 simultaneously and then turn the |
| power switch on. Put the handset back on the base and press |
| the PAGE button until you hear a beep. |
| • If a power outage occurs while the handset is away from the |
| base, the handset must be returned to the base when the |
| power returns. |
|
|
No link between base and handset.
ID code between handset and base could be lost. Follow these instructions: Make sure power switch on the handset is OFF. Turn the power switch ON while holding down digit 2 and 8 simultaneously. Put the handset down on the base. Press “PAGE” button until beep sound comes out. Beep
sound indicates that ID code is correctly restored.
16
