About the ice and water dispenser.
To Use the Dispenser
| Press the rim of the glass gently against the dispenser pad. |
| Set the selector switch to CUBES, CRUSHED ICE (on some |
| models) or WATER. |
| The spill shelf is not |
| spotting, the shelf and its grille should be cleaned |
| regularly. |
Spill Shelf | If no water is dispensed when the refrigerator is first installed, there |
| may be air in the water line system. Press the dispenser pad for at |
| least two minutes to remove trapped air from the water line and to |
| fill the water system. To flush out impurities in the water line, throw |
| away the first six glassfuls of water. |
| A light switch (on some models) turns the night light in |
| the dispenser on or off. The light also comes on when |
| the dispenser pad is pressed. The light in the dispenser |
| should be replaced with a 7 watt maximum bulb when it |
| burns out. |
CAUTION: Never put fingers or any other objects into the ice crusher discharge opening.
Ice Storage Bin
To remove:
Lift the left corner to free the bin from the shelf. Pull the bin straight out while supporting it at front and back.
| To replace: |
| Slide the bin back until the tab on the bin locks into the |
Rotate | slot on the shelf. If the bin does not go all the way back, |
| remove it and turn the drive mechanism 1/4 turn. Then |
| push the bin back again until the tab on the bin locks |
| into the slot on the shelf. |
Drive
Mechanism
Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service
13
