Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

About the dishwasher control panel.

3Enhancements

The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.

DELAY HOURS You can delay the start of a wash cycle for up to 24 hours (depending on model). Press the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle; then press START/RESET.

The machine will count down and start automatically at the correct time.

NOTE: To cancel the DELAY HOURS selection before the cycle begins, repeatedly press the DELAY HOURS pad until the display is blank.

ADDED HEAT When selected, the cycle will run longer with heating element on to improve both wash and dry performance.

NOTE: Cannot be selected with RINSE ONLY cycle.

STEAM For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected PRIOR to starting the cycle. The STEAM option adds 26 minutes to the cycle time.

NOTE: Cannot be selected with RINSE ONLY cycle.

HEATED DRY When HEATED DRY is off, dishes will air dry.Light Off

HEATED DRY Turns the heater on for faster drying. This will extend the total cycle time between Light On 8 and 38 minutes depending on the cycle selected. NOTE: Cannot be selected with

RINSE ONLY cycle.

LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle.

Children cannot accidentally start dishwasher by touching pads with this option selected.

To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds.

The light above the lock pad will turn off. To lock the dishwasher, press and hold the

HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on.RESET To change a cycle after washing starts…

Touch the START/RESETpad to cancel the cycle. The START/RESETlight will flash while the water is pumped out if needed. This takes approximately 2 minutes.

4Start

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad once to begin the cycle. Water fill begins immediately, and approximately 60 seconds later the wash action begins.

When the dishwasher door is fully closed and latched, the control panel lights will display the last settings you selected. If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate the display, open and close the door or press any pad.

5Clean

The CLEAN light will illuminate and a double beep will sound when a wash cycle is complete. The CLEAN light will turn off when the door is opened.

8