Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation.
2.In an area where it will come in contact with curtains or drapes.
3.On carpet . The floor MUST be a hard surface with a maximum slope of 1/2″ per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4″ impregnated plywood sheet solidly attached to existing floor covering.
IMPORTANT:
Minimum Installation Clearances
•When installed in alcove: Sides, Rear, Top = 0″ (0 cm)
•When installed in closet: Sides, Rear, Top = 0″ (0 cm), Front = 1″ (2.54 cm)
•Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm2), located 3″ (7.6 cm) from top and bottom of door
CONTRACTOR DIMENSIONS
BACK
21”
(533 mm) 6.25”
(159 mm)
4” (102 mm)
29.75”
(756 mm)
27.75”
(705 mm)
ROUGH-IN DIMENSIONS
FRONT
23.5”
(597 mm)
SIDE
26.6”
(676.5 mm)
*NOTE:
Washer legs have 0.75” (19 mm) adjustability. Stacked: 67.7” (171.8 cm)
33.4”*
(849 mm)
33.4”*
(849 mm)
14