GE 17 Reversing The Door Swing, 11PLUG IN THE REFRIGERATOR, 12START THE ICEMAKER, Important Notes

Installation Instructions

11PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.

12START THE ICEMAKER

On power switch models, set the icemaker power switch to the l (on) position. On feeler arm models, move the feeler arm to the ON (down) position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (–9°C) or below. It will then begin operation automatically.

Power switch

Power switch model

Feeler Arm in the

STOP (up) position

Feeler Arm in

the ON (down) position

Feeler arm model

NOTE: In lower water pressure conditions, the water valve may turn on up to 3 times to deliver enough water to the icemaker.

2

REVERSING THE DOOR SWING

IMPORTANT NOTES

When reversing the door swing:

•Read the instructions all the way through before starting.

•Handle parts carefully to avoid scratching paint.

•Set screws down by their related parts to avoid using them in the wrong places.

•Provide a non-scratching work surface for the doors.

IMPORTANT: Once you begin, do not move the cabinet until door-swing reversal is completed.

These instructions are for changing the hinges from

the right side to the left side—if you ever want to change the hinges back to the right side, follow these same instructions and reverse all references to left and right.

TOOLS REQUIRED

Phillips screwdriver Masking tape

	T20 or T25 Torxdriver,
5/16″ hex-head
	(needed for some
socket driver
	models)

5/16″ open-end
	Putty knife or thin-blade
screwdriver	wrench

17