Installation Instructions

1INSTALLING THE WATER LINE (CONT.)

11PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.

12START THE ICEMAKER

On power switch models, set the icemaker power switch to the l (on) position. On feeler arm models, move the feeler arm to the ON (down) position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (–9°C) or below. It will then begin operation automatically.

Power switch

Power switch model

Feeler Arm in the

STOP (up) position

Feeler Arm in

the ON (down) position

Feeler arm model

NOTE: In lower water pressure conditions, the water valve may turn on up to 3 times to deliver enough water to the icemaker.

2REVERSING THE DOOR SWING
IMPORTANT NOTES

When reversing the door swing:

•Read the instructions all the way through before starting.

•Handle parts carefully to avoid scratching paint.

•Set screws down by their related parts to avoid using them in the wrong places.

•Provide a non-scratching work surface for the doors.

IMPORTANT: Once you begin, do not move the cabinet until door-swing reversal is completed.

These instructions are for changing the hinges from

the right side to the left side—if you ever want to change the hinges back to the right side, follow these same instructions and reverse all references to left and right.

TOOLS REQUIRED

 

Phillips screwdriver

 

Masking tape

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

T20 or T25 Torxdriver,

 

5/16″ hex-head

 

 

 

 

 

(needed for some

 

socket driver

 

 

 

 

 

models)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5/16″ open-end

Putty knife or thin-blade

screwdriver

 

wrench

 

 

 

 

 

 

16