GE 21006 manual Tone/Pulse

TONE/PULSE

Most telephone systems use tone dialing, however, some may still use pulse dialing. This system is pre-set to tone dialing. Depending on your service type, set the dialing mode as follows:

Make sure your handset is in the menu mode.

1.Press the cid/vol (up and down arrow) buttons to move the cursor to

TONE/PULSE.

2.Press the OK soft key and SET TONE/PULSE 1TONE 2PULSE shows in the display.

3.Use the touch tone pad to select 1 for TONE dialing or 2 for PULSE dialing, or use the cid/vol (up and down arrow) button to scroll to 1 (TONE) or 2 (PULSE) dialing.

4.Press the OK soft key to save your selection. The display returns to the main menu.

NOTE: Press the EXIT soft key once to keep the previous setting and return to the main menu.

If you aren't sure which dialing system you have, set the telephone to tone dialing and make a test call. If the call connects, the setting is correct. If the call does not connect, set the telephone to pulse dialing.

REGISTRATION

The dual handsets included with the 21006 are pre-registered at the factory and are ready to use. However, if you want to name a handset (i.e.:YOUR NAME), you must re-register the handset by following the steps below. When a handset is named, it works much like Caller ID for internal call. Handset names appear in the display box when you make and receive internal calls.

During the registration process, keep the handset near the base. Make sure your handset is in the menu mode.

14