Area Code

From the Handset Setup Menu:

1.Press the vol/CID ( 6 or 5) button to scroll to the AREA CODE sub-menu.

2.Press the menu ok/mute button to enter the menu. SET AREA CODE - - - shows in the display. The default setting is - - -.

3.Use the touch-tone pad to enter your 3-digit area code.

4.Press the menu ok/mute button to confirm. You will hear a confirmation tone and the new area code shows in the display.

NOTE: To restore the default setting to - - -, press and release the del/conf/ intercom button when SET AREA CODE shows in the display.

Tone/Pulse

From the Handset Setup Menu:

1.Press the vol/CID ( 5 or 6) button to scroll to the TONE PULSE sub-menu.

2.Press the menu ok/mute button to enter the menu. TONE/PULSE 41TONE 2PULSE shows in the display. The default setting is “1 TONE”.

3.Use the touch-tone pad or vol/CID ( 5 or 6) to enter 1 TONE or 2 PULSE.

4.Press the menu ok/mute button to confirm. You will hear a confirmation tone and your selection shows in the display.

Registration

Your packaged handset(s) are pre-registered and ready to use. It is not recommended that a handset be registered again unless absolutely necessary.

From the Handset Setup Menu:

1.Press the vol/CID ( 6 or 5) button to scroll to the REGISTRATION sub-menu.

2.Press the menu ok/mute button to enter the menu. REGISTRATION 1YES 42NO shows in the display. The default setting is 2NO.

3.Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the vol/CID ( 6 or 5) button to scroll to 1YES or 2NO.

4.If you select YES, press the menu ok/mute button. HOLD BASE PAGE FOR 5 SECONDS, THEN PRESS HANDSET MENU OK shows in the display. (Your handset should be held near the base during registration process.)

21

Page 21
Image 21
GE 28118 manual Area Code, Tone/Pulse, Registration