1

Other Information
Unit beeps
• Clean charging contacts on cordless handset.
• See solutions for “No dial tone”.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program correctly?
• Did you follow proper dialing sequence?
Handset displays "SEARCHING" or "NOT REGISTERED" and cannot link up
with the base when the TALK/CALL BACK button is pressed.
• Handset may be out of range of the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place the handset on
the cradle for at least 2 to 3 minutes.
• Disconnect the power adaptor and plug it in again. Then place the handset
on the cradle for at least 2 to 3 minutes.
Handset displays "NOT REGISTERED"
• Follow the programming in the telephone procedures to re-register the
handset to the base.
• Press the SELECT button to begin handset registration. Follow instructions
on Handset screen.
Registration did not work
• Charge the batteries for 16 hours.
• Uplug and then plug in the power adaptor.
Caller ID Solutions
No Display
• Charge or replace the batteries.
• Make sure that the unit is connected to a non-switched electrical outlet.
Disconnect the AC power adaptor from the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid Caller
ID information during the silent period after the rst ring.