Philips SBC RU 120 POWER/DIGIT Toggle, Troubleshooting Guide, Solution, Try the Autosearch method

XP SBC RU 120 16-06-2000 10:29 Pagina 5

+

PROGVOL

-

VOL

+

PROG

-

Instructions for use

POWER/DIGIT TOGGLE

Even when your TV can be activated by using a digit key only (e.g. digit number 1) instead of using the power key, you need to install the "Power/Digit Toggle" function. After you installed this function, the power key will send out the "power on/off" code, the first time you press the "power" key and the "digit 1" code when you press the "power" key for the second time. In this way it is possible to activate your TV even when it responds to digit codes only. To install this "Power/Digit Toggle" function, follow the following procedure:

1 Look up the "Power/Digit toggle" code in the code list (centre of this manual).

2 Press and hold power and mute keys simultaneously – for about three seconds – until the green LED lights up. (Release the keys: the green LED should stay on).

3 Enter the 6 digit "Power toggle" code within 30 seconds.

– The green LED flashes twice.

Follow the same procedure to cancel the "Power/Digit toggle" function.

English

TROUBLESHOOTING GUIDE

•Problem:

– Solution:

•Equipment is not responding and the green light does not flash when you press a button.

–Replace batteries with two new 1.5 volt, type RO3, UM4 or AAA batteries.

•Equipment is not responding, but the green light does flash when you press a button.

–Aim the SBC RU120 at the equipment and be sure that there are no obstructions between the SBC RU120 and the equipment.

• The SBC RU120 is not performing commands properly.

– You may be using the wrong code. Try repeating Set up using another code, listed under your brand, or start the Autosearch Set-up over again to locate the proper code.

If the equipment still doesn’t respond, call the help-line and we’ll put you back on track.

•Your brand is not listed in the code list.

– Try the Autosearch method.

5