GE 45130 user manual Closed, Preparing the Garage Door Sensor for Installation

Preparing the Garage Door Sensor for Installation

The Garage Door Sensor is a self-contained Sensor. Before installing open the battery door and, remove the yellow battery isolation tape from the Garage Door Sensor. This activates the Lithium battery inside the Garage Door Sensor. The approximate battery life is up to two years. When replacing the battery it is recommended to replace all Sensor batteries at the same time in order ensure proper operation of the entire system.

Note: When using doublesided tape apply to clean dry surface.

The Garage Door Sensor is intended to be positioned on the interior side of the garage door at the bottom. The Garage Door Sensor must be mounted vertically so the detection cylinder is able to move freely up and

Closed Open

down. Select a position on the garage door frame near bottom edge. To not damage the Garage Door Sensor when the door closes, position the Garage Door Sensor with the detection rod retracted and the