How do I turn on the air conditioner?

You can use the ON/OFF Pad or the remote control to turn the air conditioner on and off.

What does the ENERGY SAVER feature do?

The ENERGY SAVER feature controls the fan and helps in cycling the compressor on and off, resulting in wider variations of room temperature and humidity.

How do I set the timer for the air conditioner?

You can set the timer to automatically turn the air conditioner on or off using the TIMER Pad on the air conditioner or the remote control.

Controls, Operating Instructions Safety Instructions, Consumer

Operating Instructions Safety Instructions

About the controls on the air conditioner—models with touch pads.

Features and appearance will vary.

Timer on

Cool on

Fan on

Energy

Saver on

FAN

Air Conditioner ControlsRemote Control

Controls

	ON/OFF Pad	NOTE: On some models, the ENERGY SAVER feature
	Turns air conditioner on and off.	cannot be set on the air conditioner. It must be set using
	Turns air conditioner on and off.	the remote control.
		the remote control.

Support Troubleshooting Tips Installation Instructions

Display

Shows the set temperature or time remaining on timer.

MODE

Use to set the air conditioner to COOL or FAN mode.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode.

FAN Pad

Use to set the fan speed to LOW (F1), MED (F2) or HIGH (F3).

ENERGY SAVER (on some models)

Controls the fan.

ON—The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. NOTE: The fan will continue to run for a short time after the compressor cycles off.

OFF—The fan runs all the time, while the compressor cycles on and off.

This feature must be set at OFF in order to use the fan settings (on the mode control).

CIRCULAIRE (on some models)

For continuous side-to-side air circulation (cool settings only), set the Circulaire switch to ON.

For fixed side-to-side air direction, turn ON until the desired air direction is obtained, then turn it OFF.

TIMER Pad

ON—When the air conditioner is off, it can be set to automatically come on in 1 to 12 hours or 1 to 24 hours (depending on model) at its previous setting. Each touch of the TIMER pad or the INCREASE ▲ / DECREASE ▼ pads (depending on model) will set the timer

in hours.

OFF—When the air conditioner is on, it can be set to automatically turn off in 1 to 12 hours or 1 to 24 hours (depending on model). Each touch of the TIMER pad or the INCREASE ▲ / DECREASE ▼ pads (depending on model) will set the timer in hours.

To cancel the timer, press the TIMER pad until the display time disappears.

Remote Control Signal Receiver

Consumer

Remote Control

■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

■The remote control signal has a range of up to 21 feet.

■Make sure nothing is between the air conditioner and the remote control that could block the signal.

■Make sure batteries are fresh and installed correctly as indicated on the remote control.

GE AGL24 Controls, Operating Instructions Safety Instructions, Consumer, Remote Control, Display

Models: AGL24 AGL18 AGW24 AGV24 AGQ24