GE ASQ28 owner manual Power Outage Recovery Feature, Cool Mode, Fan Mode, Vent Control

ge.com

Additional controls and important information.

Do Not Operate in Freezing Outdoor Conditions

This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

When the air conditioner is turned on, it will automatically start in the setting last used.

Power Outage Recovery Feature

In the case of a power outage or interruption, the	Sleep features will reset to the original setting.
unit will automatically re-start in the settings last	You may need to set a new time if desired.
used after the power is restored. The Timer and

Safety Instructions Operating

Cool Mode

Use the Cool mode with High (3), Med (2) or Low (1) fan for cooling. Use the Increase ▲ / Decrease ▼ pads to set the desired temperature between 64°F and 86°F in 1°F increments.

A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned

on while set to Cool, it will take approximately 3 minutes for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling—Select the Cool mode and High (3) or Med (2) fan with a middle set temperature.

For Maximum Cooling—Select the Cool mode and High (3) fan with a lower set temperature.

For Quieter & Nighttime Cooling—Select the Cool mode and Low (1) fan with a middle set

temperature.

NOTE: If you switch from a Cool setting to Off or to

a fan setting, wait at least 3 minutes before switching back to a Cool setting.

Instructions Installation Instructions

Fan Mode

Use the Fan at High (3), Med (2) or Low (1) to provide	Since fan only settings do not provide cooling,
air circulation and filtering without cooling.	a temperature setting will not be displayed.

Vent Control

The vent control is located on the inside of the air louvers in the lower right corner.

When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

To open the vent, push the lever to the right. To close it, push it to the left.

Air Direction—Up and Down

Fingertip pressure on the horizontal louvers adjusts the air direction up or down.

Air Direction—Side-to-Side

The side-to-side air direction is adjusted

by the louver levers or by grasping and moving the inner vertical louvers.

5

Troubleshooting Tips Consumer Support