Window Installation Instructions
1WINDOW REQUIREMENTS
•These instructions are for a standard
•All supporting parts must be secured to firm wood, masonry or metal.
•The electrical outlet must be within reach of the power cord.
181⁄2″ min.
30″ to 40″
(With accordion panels)
2STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly.
To adjust for this, attach a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2″
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece of wood on the sill to make it 1/2″ higher than the top of the storm window frame or the vinyl frame.
Attach securely with nails or screws provided by the installer.
3PREPARE THE WINDOW
Cut the window sash seal to the proper length. Peel off the backing and attach the seal to the underside of the window sash.
4REMOVE THE FRONT GRILLE (IF ATTACHED)
AOpen the inlet grille
downward by pulling out the upper corners of the inlet grille.
Lift it up and off.
BGrasp the filter
at the top center and pull it out.
CRemove the screw
from the grille.
DGently but firmly grasp
1/2″ higher 
than storm window 
frame
Storm window 
frame
1/2″ higher
than vinyl frame (on some windows)
Wood
Sill
Vinyl frame
the lower grille corners,
press in on the case sides and pull forward to release.
NOTE: Do not pull the bottom edge toward you more than 3″ or you
may damage the tabs of the grille.
ELift the grille up and off the top tabs.
9
