3 | Install the Air Conditioner in the Window | |
A | Cut two pieces of adhesive back foam seal to | |
the height of the window opening. Remove |
the backing and apply to the vertical inside edges of the window frame and the sliding window that will rest against the air conditioner. Cut one piece to the width of the window opening and apply to the top inside edge of the window frame.
Adhesive back foam seal
|
| 5 | 6 | 7 |
| 4 |
|
| 8 |
| 3 |
|
| 9 |
OPEN | 2 |
|
| 10 |
ED |
| 1 |
|
|
TEMP
MODE
BSlide the air conditioner onto the support platform. Be sure the side channel butts against the vertical side edge of the window frame.
CDrill two 1/8″ holes in the window channel frame through the existing holes in the bottom bar. Screw 2 type C screws through these holes.
Bottom bar
Window channel frame
NOTES:
■If the air conditioner does not fit securely, remove it and readjust the leveling bolt.
■Make sure the air conditioner is firmly anchored to the window channel frame.
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions
4 | Secure the Window and Install the Window Side Gasket | ||
A | Attach the window stopping clips on the top |
| |
| and the bottom of the window frame (sliding | clip | |
|
| windows only). | Stopping |
|
|
| |
| B | Cut the foam window side gasket to the |
|
|
| proper length and stuff it between the 2 |
|
|
| windows. |
|
|
| 5 | 6 | 7 |
| 4 |
|
| 8 |
| 3 |
|
| 9 |
OPEN | 2 |
|
| 10 |
ED |
| 1 |
|
|
TEMP
MODE
Window side gasket
Stopping clip
11
Troubleshooting Tips Consumer Support