Installation Instructions
PREPARE TO INSTALL THE RANGE
MATERIALS YOU MAY NEED
Tin Snips | Lag Bolts | Anchor Sleeves |
(For
(UL Approved 40 AMP) |
| ||
Squeeze Connector | |||
(For Conduit | |||
4‘ Long | 4‘ Long | ||
Installations Only) | |||
|
| ||
TOOLS YOU WILL NEED
Drill with 1/8″ Bit | Safety Glasses |
Adjustable Wrench |
|
| Tape Measure |
Pliers | Pencil |
1/4″ Nut Driver | Level |
Phillips Screwdriver |
PARTS INCLUDED
1 REMOVE SHIPPING MATERIALS
Remove packaging materials. Failure to remove packaging materials could result in damage to the appliance.
41
2 PREPARE THE OPENING
Allow 11⁄2″ spacing from the range to adjacent vertical walls above the cooktop surface.
Allow 30″ minimum clearance between the surface units and the bottom of unprotected wood or metal top cabinet, and 15″ minimum between the countertop and adjacent cabinet bottom.
EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.
If cabinet storage is installed, reduce the risk by installing a range hood that projects horizontally a min. of 5″ beyond the bottom of the cabinets. Make sure the wall covering, countertops and cabinets around the range can withstand heat generated by the range, oven or cooktop up to 200°F.
| Not less than the |
Hood | width of the range |
| |
5″ Min. |
|
30″ | 15″ |
Min. | Min. |
Locate the outlet box within either shaded area.
Wall
| 11⁄2″ |
|
|
|
|
| Min. |
| C of range |
| |
| Wall | 71⁄2″ |
| ||
| L |
|
| ||
| Outlet |
| 7″ | 71⁄2″ |
|
Install the | box |
| 31⁄2″ |
|
|
outlet box |
|
|
| 5″ | |
on either |
|
|
| Floor |
|
side of the C |
|
|
| 1 | |
L |
|
|
|
| 2 ⁄4″ |
Cord
Flooring under the range
Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting.
When moving the range on this type of flooring, it should be installed on a 1/4″ thick sheet
of plywood (or similar material) as follows:
When the floor covering ends at the front
of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. This will allow the range to be moved for cleaning or servicing.
